🚘Conveyor Troubleshooting

TLDR; please do some basic troubleshooting before putting in a maintenance request.

If conveyor doesn’t run, it could be caused by one or more items failing. We need to determine what caused the issue, correct it, and let the right people know about it.

• Pulse Switch Failure

  • Look at tunnel watch screen for an error

  • Reach out to maintenance to enable simulated pulse

• Low Hydraulic Oil

  • Refill it

• Debris stuck in chain

  • Move at all grates and clear the debris

• E-Stop buttons

  • Pull out all E-Stops in Tunnel, electrical panel, Buff N Dry, Petit, etc)

• Tripped breaker

  • Force back on and let maintenance know

• Low Air Pressure

  • Check the air pressure gauge for the conveyor chain (should be xy PSI)

  • Let maintenance know

  • Check the air compressor is on and working

• If conveyor shoots out a bunch rollers

  • This usually means the tunnel is expecting to receive a car but there's no car

    • Cover the entry eyes with your hand to run a ghost car

  • Roller up solenoid could be stuck in the up position

    • Tell maintenance

• If conveyor doesn’t shoot up rollers

  • Roller up solenoid could be stuck in the down position

    • Use the manual lever until maintenance can replace it

  • Check air pressure gauge for roller up solenoid

    • Let maintenance know

• If pit overflows

  • Throw a sump pump in the pit until maintenance gets there

  • Unclog drain / call maintenance

• Pressing send on the loader screen and no roller comes up